Siemens SIMATIC HMI Series Operating Instructions Manual page 161

3. Open the "Assign IP" dialog using the "Assign IP" button.
The following functions are available in the menu bar of this dialog:
4. Use "Settings > Interface" to select the interface of the HMI device that is connected to
the subnet that is to be searched for other devices, e.g. X1.
5. If necessary, select "Settings > Filter" to find a controller with a specific MAC address or
controllers of a certain type.
6. Select "Network > Scan > Start".
The search for accessible devices located in the subnet of your HMI device is started.
7. To stop scanning, press "Network > Scan > Stop".
The scanning is stopped and the devices already found are shown in the list.
Mobile Panels 2nd Generation
Operating Instructions, 09/2018, A5E33876626-AC
Menu Submenu/Entry
Network Scan Start
Stop
Exit
Device Download IP
Devicename
All
Flash
Reset to Factory
Settings Filter All devices
MAC Address Find a controller with a specific MAC address
Device Type
Interface
Parameterizing the Mobile Panel
5.15 Functions for service and commissioning
Function
Start search for available devices in the subnet of the
HMI device
Stop search for available devices in the subnet of the
HMI device
Close the "Assign IP" dialog
Update IP address of the selected device
Update device name of the selected device
Update IP address and device name of the selected
controller
Causes the display of the selected HMI device or the
"RUN/STOP" LED of the selected controller to flash
Deletes the IP address and device name of the selected
device, provided that this function is supported by the
selected device and allowed by the security settings.
Find all controllers in the subnet of the HMI device
Find controllers of a certain type
Select the interface of the HMI device for the search
161