EMS FirePoint 5000 Step-By-Step Manual page 29

EMS 5000 FIREPOINT
f) ALL OFF : The selected sounder will stop sounding. (i.e. Silence)
g) RX TEST : The receiver in the selected sounder will be sent a test
message, the sounder will receive
acknowledgement message back to the 5000 FirePoint panel.
h) TEST: The selected sounder will sound for four seconds and then
turn off. The
acknowledgement message back to the 5000 FirePoint panel.
i) SET SYS: The 5000 FirePoint panel will send a message to the select
sounder, which sets the
sounder then sends an acknowledgement message back to the 5000
FirePoint panel.
j) JOIN GRP: The 5000 FirePoint panel will send the zone information
to the selected
acknowledgement back to the 5000 FirePoint panel.
k) SET LS CH: The 5000 FirePoint panel will send a message to the
selected sounder which enables the lesson change, feature for the
device.
15 Press  key once and the screen will display:
16 Press Yes key and the screen will now display:
This timer will count down to 0, when the timer reaches 0 the retry
should change to 6 and a message is sent to the sounder. If not, that
means the panel is still busy and the timer will start again, when the
retry number decreases listen for the selected sounder to activate.
When the selected sounder has activated it sounds for four seconds
and resets itself,
message. (ACK)
If the acknowledgement message has been received and a fault has
not been reported the test is now complete.
©2015 EMS Security Group Ltd. All rights reserved.
sounder will
system code in the selected
sounder, the
watch the
29
the message and
listen to it self
selected sounder
display for the
TSD258 Iss 3 25/06/15 AJM
send an
and send an
sounder. The
sends an
Action :
| TEST |
>Do Action
|^^^^^^^^^^^^^^^^^|
Yes= Select
Device 025 Timer 9
Retry 07
REPLY NONE
Push Any Key
acknowledgement
Device 025 Timer 5
Retry 04
REPLY ACK
Push Any Key
<
Time
Time
Time