EMS FirePoint 5000 Step-By-Step Manual page 10

EMS 5000 FIREPOINT
6 Press Yes key and the screen will now
display: (move on to step 8 if H/W)
7 Press Yes key once the Screen will
now display:
NOTE : PAN is for a Hardwired based System.
NET is for a Radio LAN based system.
8 Press  key one time and the screen will
display:
9 Press the Yes key to change the panel
number until the required panel number is
shown: (e.g. 04)
10 Press  key one time and the screen will
display:
11 Press 0 key and the screen will now
Display:
12 Enter the device number that you want to
isolate (e.g. 125) then press Yes key and
screen will now display:
13 Press  key one time and the screen will
display:
14 Press Yes key once the Screen will
now display:
15 Press  key one time and the screen will
display:
16 Press Yes key once the Screen will now display:
©2015 EMS Security Group Ltd. All rights reserved. TSD258 Iss 3 25/06/15 AJM
10
|* Network Status * |
>Panel Type : PAN <
|Panel : 00 |
Yes= Select Time
|* Network Status * |
>Panel Type : NET <
|Panel : 00 |
Yes= Select Time
|Panel Type : NET |
>Panel : 00 <
|Device : 00 |
Yes= Select Time
|Panel Type : NET |
>Panel : 04 <
|Device : 00 |
Yes= Select Time
|Panel : 04 |
>Device : 00 <
|Status : Active
Yes= Select Time
Enter Device
(Number 1-256)
Number > _
Yes = Finish Time
Time
|Panel : 04 |
>Device : 125 <
|Status : Active
Yes= Select Time
|Device : 125 |
>Status : Active<
|Transmit Event |
Yes= Select Time
|Device : 125 |
>Status : Isolate<
|Transmit Event |
Yes= Select Time
|Status : Isolate |
>Transmit Event <
|^^^^^^^^^^^^^^|
Yes= Select Time
Device 125 on NET 04
Set to ISOLATED
Push Any Key Time