EMS FirePoint 5000 Step-By-Step Manual page 19

EMS 5000 FIREPOINT
15 Take the device you want to log on.
Press and hold the logon button for 2-3
seconds (e.g. Figure 2) and the screen will
now display:
16 Press Yes key once and the screen will now
display:
17 Press No key three times and the screen will
now display:
Note: After logging the device on to the system there will be two
faults: -
st
1 fault is processor reset. (Just silence and reset E.g. Pg. 3)
nd
2 fault is the Tamper. (Make sure the device tamper is clear then
silence and reset E.g. Pg. 3)
18 After the faults have been cleared turn the
Control key switch to the off position and the
screen will now display:
©2015 EMS Security Group Ltd. All rights reserved.
FIGURE 2
TSD258 Iss 3 25/06/15 AJM
19
Logon Default Device
125
Yes= Select Time
Added Default Device
125
Yes= Select Time
|Slot is :IN USE |
>Logon is DISABLED<
| /\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\ |
01 FAULT TOT 02
Default Device 125
ZONE 01 DEVICE 125
Status Normal
Date Time