How To Test Individual Sounders - EMS FirePoint 5000 Step-By-Step Manual

EMS 5000 FIREPOINT
15 Press  key one times and the screen will
display:
16 Press Yes key, the screen will stay the same but
the test LED will start flashing to show that all
the zones are in test.
NOTE: Check the other panels to make sure the test LED has stopped
flashing to ensure Sounders/Relays are ready to activate.

15. How To Test Individual Sounders

To test individual sounders on the 5000 FirePoint, insert the key into the panel
controls keyswitch, located at the right of the panel.
Step
No
1 Turn the key to the on position and the
screen will display:
2 Press 0 key and the screen will now display:
3 Press  key three times and the screen will
display:
4 Press Yes key and the screen will now display:
5 Press  key four times and the screen will
display:
6 Press Yes key and the screen will now display:
©2015 EMS Security Group Ltd. All rights reserved.
Action
27
| SINGLE
>ALL
| TWO PHASE
Yes= Select
| SINGLE
>ALL
| TWO PHASE
Yes= Select
Screen Display
Panel in Access
Date
|***Options ****|
>Passwords
|Time and Date |
Yes =Select
|
Logging
>Fire System Opts<
|Remote Access
Yes = select
|** Fire system **|
>Dev. Isolate/Test<
| Net. Isolate/Test |
Yes= Select
|Brigade Isolate |
>Engineers Config<
|Printer Options |
Yes= Select
Enter Your PIN
For Access>
Then Press YES
TSD258 Iss 3 25/06/15 AJM
|
<
|
Time
|
<
|
Time
Time
<
Time
|
|
Time
Time
Time
Time