Display Rip Interface - H3C S5820X Series Command Reference Manual
Layer 3 - ip routing
Hide thumbs
Also See for S5820X Series:
- Command reference manual (486 pages) ,
- Configuration manual (252 pages) ,
- High availability configuration manual (233 pages)
Table of Contents
Advertisement
<Sysname> display rip 100 database
10.0.0.0/8, cost 1, ClassfulSumm
10.0.0.0/24, cost 1, nexthop 10.0.0.1, Rip-interface
11.0.0.0/8, cost 1, ClassfulSumm
11.0.0.0/24, cost 1, nexthop 10.0.0.1, Imported
Table 3-2 display rip database command output description
Field
X.X.X.X/X
cost
classful-summ
Nexthop
Rip-interface
imported
display rip interface
Syntax
display rip process-id interface [ interface-type interface-number ]
View
Any view
Default Level
1: Monitor level
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
interface-type interface-number: Specifies an interface.
Description
Use the display rip interface command to display the RIP interface information of the RIP
process.
If no interface is specified, information about all RIP interfaces of the RIP process is displayed.
Examples
# Display all the interface information of RIP process 1.
<Sysname> display rip 1 interface
Interface-name: Vlan-interface 1
Address/Mask:1.1.1.1/24
MetricIn:5
MetricOut:5
Split-horizon/Poison-reverse:on/off
Current packets number/Maximum packets number:234/2000
Destination address and subnet mask
Cost of the route
Indicates the route is a RIP summary route.
Address of the next hop
Routes learnt from a RIP-enabled interface
Routes redistributed from other routing protocols
Version:RIPv1
MetricIn route policy:123
MetricOut route policy:234
3-6
Description
Input/Output:on/on
Advertisement
Table of Contents
