Display Ospfv3 Peer Statistic - H3C S5820X Series Command Reference Manual

display ospfv3 peer statistic

Syntax
display ospfv3 peer statistic
View
Any view
Default Level
1: Monitor level
Parameters
None
Description
Use the display ospfv3 peer statistic command to display information about all OSPFv3 neighbors
on the router, that is, numbers of neighbors in different states.
Examples
# Display information about all OSPFv3 neighbors.
<Sysname> display ospfv3 peer statistic
OSPFv3 Router with ID (1.1.1.1) (Process 1)
----------------------------------------------------------------------
Area ID
0.0.0.0
Total
Table 9-12 display ospfv3 peer statistic command output description
Field
Area ID
Down
Init
2-Way
ExStart
Exchange
Loading
Full
Neighbor Statistics
Down Init 2-way
0 0 0
0 0 0
Area ID
In this state, neighbor initial state, the router has not received any information from a
neighboring router for a period of time.
In this state, the device received a Hello packet from the neighbor but the packet
contains no Router ID of the neighbor. Mutual communication is not setup.
Indicates mutual communication between the router and its neighbor is available.
DR/BDR election is finished under this state (or higher).
In this state, the router decides on the initial DD sequence number and master/slave
relationship of the two parties.
In this state, the router exchanges DD packets with the neighbor.
In this state, the router sends LSRs to request the neighbor for needed LSAs.
Indicates LSDB synchronization has been accomplished between neighbors.
ExStar Exchange Loading Full
0 0 0
0 0 0
Description
9-18
1
1