Rip Authentication-Mode - H3C S5820X Series Command Reference Manual

Use the undo rip command to disable a RIP process.
By default, no RIP process runs.
Note that:
If no VPN instance is specified, the RIP process will run under public network instance.
You must create a VPN instance before you apply a RIP process to it. For related
configuration, see the ip vpn-instance command.
You must enable the RIP process before configuring the global parameters. This limitation
is not for configuration of interface parameters.
The configured interface parameters become invalid after you disable the RIP process.
Examples
# Create a RIP process and enter RIP process view.
<Sysname> system-view
[Sysname] rip
[Sysname-rip-1]

rip authentication-mode

Syntax
rip authentication-mode { md5 { rfc2082 key-string key-id | rfc2453 key-string } | simple
password }
undo rip authentication-mode
View
Interface view
Default Level
2: System level
Parameters
md5: MD5 authentication mode.
rfc2082: Uses the message format defined in RFC 2082.
key-string: MD5 key string with 1 to 16 characters in plain text format, or 1 to 24 characters in
cipher text format. When the display current-configuration command is used to display
system information, a 24-character cipher string is displayed as the MD5 key string.
key-id: MD5 key number, in the range of 1 to 255.
rfc2453: Uses the message format defined in RFC 2453 (IETF standard).
simple: Plain text authentication mode.
password: Plain text authentication string with 1 to 16 characters.
Description
Use the rip authentication-mode command to configure RIPv2 authentication mode and
parameters.
Use the undo rip authentication-mode command to cancel authentication.
Note that the key string you configured can overwrite the old one if there is any.
Related commands: rip version.
3-20