Display Rip - H3C S5820X Series Command Reference Manual

The RIP router with this feature configured will not receive any default routes from RIP
neighbors.
Related commands: rip default-route.
Examples
# Configure all the interfaces under RIP process 1 to send only a default route with a metric of 2
to RIP neighbors.
<Sysname> system-view
[Sysname] rip 100
[Sysname-rip-100] default-route only cost 2

display rip

Syntax
display rip [ process-id | vpn-instance vpn-instance-name ]
View
Any view
Default Level
1: Monitor level
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
vpn-instance vpn-instance-name: Specifies a VPN instance name, a string of 1 to 31
characters.
Description
Use the display rip command to display the current status and configuration information of the
specified RIP process.
If process-id is not specified, information about all configured RIP processes is displayed.
If vpn-instance-name is specified, the RIP configuration of the specified VPN instance is
displayed.
Examples
# Display the current status and configuration information of all configured RIP processes.
<Sysname> display rip
Public VPN-instance name :
RIP process : 1
RIP version : 1
Preference : 100
Checkzero : Enabled
Default-cost : 0
Summary : Enabled
Hostroutes : Enabled
Maximum number of balanced paths : 8
Update time
Suppress time :
: 30 sec(s) Timeout time
120 sec(s) Garbage-collect time :
:
3-3
180 sec(s)
120 sec(s)