SawStop RT-LFT Owner's Manual page 12

If your router is significantly smaller than
7
the diameter of the clamp, use a router
reducer collar so the clamp can hold
your router more securely. To install,
slide either the 3.5" or 3.25" router
reducer collar (1.53 or 1.54) onto your
router, with the bent edge of the collar
extending towards the router body
(away from the collet of your router).
Some routers have small projections on the
motor housing. The clamp and router reducer
collars have semicircular indentations to
i
accommodate the projections. You may need
to turn your router so the projections line up
with the indentations in the clamp (and router
reducer collar, if installed) in order to install
your router.
Slide your router (or router and reducer
8
collar) into the opening in the clamp,
until the top of the router body is close
to, but not touching, the underside
of the aluminum router plate. If you
installed a router reducer collar on
the router, the bent edge on the collar
should rest against what is currently the
top edge of the clamp.
You may need to adjust the height of
the router in the router reducer collar
in order to make sure that the router
is close to, but not touching, the
underside of the aluminum router plate.
7
RT-LFT/RT-DCB OWNER'S MANUAL
For small routers only:
Router
Router reducer collar
(bent edge extends
towards router body)
1.53/1.54
Indentations to
accomodate various
router shapes
Short distance
between top of
router body
and router plate