Table of Contents
Advertisement
Use an 8mm hex wrench to tighten
9
the socket head cap screw (1.45) and
secure the router. Check to make sure
that the router is securely held in the
clamp by trying to lift and twist the
router.
Turn the router lift over and install in
10
the opening of the router table so the
leveling screws in the router table
support the underside of the aluminum
router plate. The collet of the router
should extend above the top surface
of the aluminum router plate, but there
should be a small gap between the top
of the router and the underside of the
aluminum router plate. The router bit
should be able to be changed at this
router elevation.
NEVER PERFORM ANY MAINTENANCE OR ADJUSTMENTS
ON YOUR ROUTER, ROUTER TABLE, LIFT, STAND, OR SAW
UNLESS THE ROUTER IS SAFELY UNPLUGGED.
1.45
RT-LFT/RT-DCB OWNER'S MANUAL
8
Hide quick links:
Advertisement
Table of Contents
