SawStop RT-LFT Owner's Manual page 20

Attach the front and rear panels
3
to the side panels using four truss
head Phillips screws (2.5) along
each edge.
Attach the Downdraft Dust Collection
4
Box to the underside of your router table.
It may be helpful to temporarily turn your
router table over, so the underside of the
table faces up, but it is not required.
Position the Downdraft Dust Collection
Box near the underside of the opening
in your router table, so the six elongated
holes in the top edge of the Downdraft
Dust Collection Box align with the six
Downdraft Dust Collection Box mounting
holes in the underside of your router
table. Insert a hex head bolt (2.18)
through a lock washer (2.17) and a
washer (2.16), then into one of the six
exposed holes in the Downdraft Dust
Collection Box and router table.
Repeat this process for the remaining
five hex head bolts, lock washers, and
washers. Use a 10mm wrench to tighten
the bolts.
i
Important Note:
If you have already attached the benchtop stand to the underside of your
27" x 16" cast iron router table, you may want to remove the rear panel
of the stand to accommodate installation of the Downdraft Dust
Collection Box, and reattach the rear panel after the dust box is attached.
15
RT-LFT/RT-DCB OWNER'S MANUAL
2.5
2.18
2.17
2.16