To Replace Shaft Seal & Cap O-Ring - Garland MWE2W Installation, Operation & Service Manual

INSTALLATION/OPERATION & SERVICE MANUAL - 1&2 PLATEN
TO REPLACE THE SHAFT SEALS
4. Lift up the seal cap through shaft and re-
place old shaft seal by the new split shaft
seal.
TO REPLACE THE SHAFT SEALS & CAP O-RINGS
1. It is recommended
that the platen be
in the down posi-
tion when replac-
ing the shaft seals.
With the control
in the OFF mode,
Press the GREEN
push button to
lower platen.
Page 56
GARLAND CLAMSHELL GRILLS WITH PRODUCT RECOGNITION
(continued)
5. Remove old screw o-rings and replace by
new o-rings. Reinstall seal cap in place and
slightly tighten screws DO NOT OVER-TIGHT.
Turn main power switch on, the platen will
lower, press green button to raised and low-
ered the platen a couple times. Final step
tighten the seal cap screws down fi rm in
place.
2. Remove carriage
block locking key
from carriage
block using a 7/16"
wrench or socket
to unscrew two
screws. The lock-
ing key will allow
the platen arms
to separate from
the shafts without
having to remove
the entire shaft as-
sembly.
PART #4527466 (12 Aug 2011)