Startup Procedure; Part #4527466 (12 Aug - Garland MWE2W Installation, Operation & Service Manual

INSTALLATION/OPERATION & SERVICE MANUAL - 1&2 PLATEN
INSTALLATION & STARTUP
During the commissioning of a Grill onto a Lonworks
network the grill has to fi rst send a service pin request
message from the grill to the Lonworks server.
The grill sends this message by following the below
procedure on the front panel control of the grill.
1. Power up grill.
2. PRESS and HOLD the
seconds. Controller will display previously selected
menu item and its corresponding item number.
3. PRESS the AND arrow buttons TOGETHER.
"CONFIGURE" will appear in the display.
4. PRESS the arrow button. "SERVICE" will appear in the
display. PRESS the
5. Press the arrow button 2X. "Lonworks Service" will
appear in the display.
6. PRESS the button.
7. Set option to "NO". Wait 10 seconds. If the Lonworks
service state was already "ON" make sure this step is
done anyway.
8. Set option to "YES". Within 10 seconds the network will
receive the Lonworks Service Pin Request.
After the grill service pin request has been sent the
Lonworks administrator will detect the service pin
message and assign an appropriate address to the grill to
enable communications.
After the Lonworks server has established this address
the communications will be activated by the Lonworks
administrator and the grill will start communicating on the
Long Network
Page 20
button for approximately 3
button.
GARLAND CLAMSHELL GRILLS WITH PRODUCT RECOGNITION
(continued)

Startup Procedure

This Garland 1&2-platen grill comes with a factory startup
at no additional charge. A startup is required to take
place BEFORE the unit is put into operation. It is the
end-user responsibility to schedule the startup with their
local Factory Authorized Service Agent, or notify Garland
Commercial Ranges at 1-800-427-6668 should you need
assistance scheduling.
A factory startup is a comprehensive grill check in which
a factory certifi ed technician will document all fi nal
settings programmed in the controller once various other
performance checks are complete. The estimated time to
complete a startup is approximately 1.5 – 2 hours. Please
keep in mind this estimated time when scheduling the
startup. After hours or overtime is not covered under
warranty and will be billed at a charge which is the
diff erence between the Garland Reimbursement rate and
the Factory Authorized Service Centers overtime charges.
A factory startup is necessary to start the warranty period.
The Authorized Service Center is required to complete
the paperwork during the startup process, and send it
to Garland Commercial Ranges for reimbursement. At
the time of receipt, Garland will start the warranty period
which will conclude at the end of 2 years.

PART #4527466 (12 Aug 2011)