Installation Of Release Material - Garland MWE2W Installation, Operation & Service Manual

INSTALLATION/OPERATION & SERVICE MANUAL - 1&2 PLATEN

INSTALLATION OF RELEASE MATERIAL

The following are the procedures for installing the Release Material sheets on the upper platen on the Garland Clamshell
grill. The components shown below are included with your grill when purchased.
1. Slide release material rod through hemmed end of the
release material sheet.
MATERIAL
ROD
RELEASE
MATERIAL
"Teflon Sheet" available from your DC
Saint Gobain DC WRIN # 02174-003
Taconic DC WRIN # 02174-000
2. Hook release material rod on brackets located at the
rear of the upper platen.
UPPER PLATEN
(SIDE VIEW)
RELEASE
MATERIAL
MATERIAL
ROD HOLDER
3. Holding the bottom of the release material sheet in
place, gently pull the sheet toward the front of the
platen, and wrap the front fl ap up and over the release
material bar on the front of the platen.
4. Place two (2) locking clips over release material sheet
and press into place over release material bar.
NOTE: Make sure release material is fi t smoothly along the
bottom surface of the upper platen.
Page 24
HEMMED
LOOP
MATERIAL
ROD
GARLAND CLAMSHELL GRILLS WITH PRODUCT RECOGNITION
FRONT FLAP
WRAPPED
OVER RELEASE
MATERIAL BAR
AND CLIPPED
LEFT & RIGHT
IN PLACE
FLAPS
5. After securing the release sheet from the back of
the platen to the front, secure it to the left and right
sides of the platen. Wrap one side of the release sheet
material around the side of the platen. Place one (1)
locking clip over the sheet and press into place over
release material bar. Repeat this procedure for the
other side of the platen.
RELEASE
MATERIAL
CLIPS
5. Check alignment and tightness of release material
against upper platen.
Release material sheets should be replaced when:
• Product sticks to release material
• Carbon build-up causes problems in taste or
appearance.
• A tear in the release material sheet's cooking area.
• Release material coating is worn off sheet.
NOTE: Rotate the release sheets on daily basis
PART #4527466 (12 Aug 2011)