Platen Leveling (Zeroing) - Garland MWE2W Installation, Operation & Service Manual

GARLAND CLAMSHELL GRILLS WITH PRODUCT RECOGNITION

PLATEN LEVELING (ZEROING)

Shoulder Bolt Assy
Leveling Point (REAR)
Shoulder Bolt Assy
Leveling Point (FRONT LEFT)
1) Enter the "LEVEL/REED SW" mode:
a) With the controller display ON and either
displaying the current menu item or displaying
"OFF" PRESS and HOLD the
seconds. Controller will display previously
selected menu item and its corresponding item
number OR "Standby / Menu Item".
b) PRESS the AND
"CONFIGURE" will appear in the display.
c) PRESS the 2X. "CALIBRATION" appears.
d) PRESS the button. "LEVEL/REED SW" appears.
e) PRESS the button. "NO" will begin to fl ash.
f ) PRESS the button. "NO" will change to "YES".
g) PRESS the button. "YES" will stop fl ashing.
h) Press the GREEN button to lower the platen.
2) Remove the shoulder
bolt grease caps..
P/N:4523323
INSERT GAP
GAUGE HERE
FROM SIDE
PART #4527466 (12 Aug 2011)
Shoulder Bolt Assy
Leveling Point (FRONT RIGHT)
button for 3
arrow buttons TOGETHER.
GRILL PLATE
INSTALLATION/OPERATION & SERVICE MANUAL - 1&2 PLATEN
3) Remove the shoulder
bolt locking caps.
Adjust Platen:
a) Using the Platen
Adjusting tool,
adjust front of
platen on both
sides (front left &
front right) until
the Gap Gauge fi ts
snugly between the
upper platen and
grill surface.
b) Move next to the
rear adjustment
and raise or lower
the rear of the
upper platen until
the Gap Gauge fi ts
snugly between the
upper platen and
grill surface. The
rear of the platen
has only a SINGLE-
POINT adjustment.
Fit the Gap Gauge
under the rear of
the platen, and
adjust until both
sides gauge equally.
IMPORTANT NOTES TO
REMEMBER WHEN LEVELING
PLATEN
• The Gap Gauge should fi t
snugly under the platen,
but STOP at the raised
emboss on the gapping
tool (No-Go).
• The rear of the platen
only has a single point
adjustment.
• DO NOT push hard to fi t
gauge under platen.
Page 51