Danfoss VLT AQUA Drive FC 202 Design Manual page 43

Selection
Normal Overload =110% current
for 60 seconds
Typical Shaft output at 400 V [kW]
Typical Shaft output at 460 V [hp]
Enclosure IP00
Enclosure IP21/NEMA 1
Enclosure IP54/NEMA 12
Output current
Continuous (at 3x380-440 V) [A]
Intermittent (at 3x380-440 V) [A]
Continuous (at 3x441-480 V) [A]
Intermittent (at 3x441-480 V) [A]
Continuous kVA (at 400 V AC)
[kVA]
Continuous kVA (at 460 V AC)
[kVA]
Max. Input current
Continuous (3 x 380-440 V) [A]
Continuous (3 x 441-480 V) [A]
1)
Max. pre-fuses [A]
Max. cable size
Motor (mm 2 /AWG 2) )
2 2)
Mains (mm /AWG )
2 2)
Loadsharing (mm /AWG )
2 2)
Brake (mm /AWG )
Estimated power loss at 400 V AC
3)
at rated max load [W]
Estimated power loss at 460 V AC
3)
at rated max load [W]
Weight, enclosure IP00/IP20 kg
[bs.]
Weight, enclosure IP21 kg [lbs.]
Weight, enclosure IP54 kg [lbs.]
4)
Efficiency
Output frequency [Hz]
Heatsink overtemp. trip [°C]
Power card ambient trip
Table 3.2 Mains Supply 3x380-480 V AC
1) For type of fuse, consult the Operating Instructions.
2) American Wire Gauge.
3) The typical power loss is at normal conditions and expected to be within
These values are based on a typical motor efficiency (eff2/eff3 border line). Lower efficiency motors add to the power loss in the frequency
converter and the opposite is also true. If the switching frequency is raised from nominal, the power losses rise significantly. LCP and typical
control card power consumptions are included. Further options and customer load can add up to 30 W to the losses (though typically only 4 W
extra for a fully loaded control card or options for slot A or slot B, each).
4) Measured using 5 m screened motor cables at rated load and rated frequency.
5) Wiring terminals on N132, N160, and N315 frequency converters cannot receive cables one size larger.
®
VLT AQUA Drive FC 202 Design Guide
P450 P500
NO NO
450 500
600 700
E2
E1 F1/F3
E1 F1/F3
800 880
880 968
730 780
803 858
554 610
582 621
787 857
718 759
900 1600
4 x 240
4 x 500 mcm
2 x 185
2 x 350 mcm
9473 10162
8527 8876
-
277 [609]
313 [689]
313 [689]
110
®
MG20Z102 - VLT is a registered Danfoss trademark
P560 P630
NO NO
560 630
750 900
F1/F3 F1/F3
F1/F3 F1/F3
990 1120
1089 1232
890 1050
979 1155
686 776
709 837
964 1090
867 1022
2000
8 x 150
8 x 300 mcm
8 x 240
8 x 500 mcm
4 x 120
4 x 350 mcm
4 x 185
4 x 350 mcm
11822 12512
10424 11595
-
-
1017/1318 [2237/2900]
1017/1318 [2237/2900]
0.98
0–590
95
85
± 15% (tolerance relates to variety in voltage and cable conditions.)
P710 P800 P1M0
NO NO NO
710 800 1000
1000 1200 1350
F1/F3 F2/F4 F2/F4
F1/F3 F2/F4 F2/F4
1260 1460 1720
1386 1606 1892
1160 1380 1530
1276 1518 1683
873 1012 1192
924 1100 1219
1227 1422 1675
1129 1344 1490
2500
12 x 150
12 x 300 mcm
6 x 185
6 x 350 mcm
14674 17293 19278
13213 16229 16624
- -
-
1260/1561
[2772/3434]
1260/1561
[2772/3434]
41
3 3