Button Of A Bus Telephone On The Bsm 650 - SSS Siedle AIB 150 Series System Manual

Button of a bus telephone on the BSM 650-...
Actuation of a contact in the
BSM 650-..., e.g. in order to open a
garage or switch on a staircase light.
1 Switch on the programming mode.
At the BNG/BVNG 650-..., press the
programming mode button briefly.
The LED 1 flashes in a 2-second
rhythm to indicate that the program-
ming mode is active.
4 Lift the receiver at the bus tele-
phone at which you wish to pro-
gram a button. Press the button you
wish to program and hold down for
4 seconds.
A protracted acknowledgement tone
is audible in the receiver.
In the BVPC 850-..., programming is
performed at the PC using bus pro-
gramming software BPS 650-...
2 Switch the BSM 650-... to the pro-
gramming mode. To do this, briefly
press the programming mode button
using a small screwdriver.
LED 1 lights up and flashes slowly
after appr. 3 seconds.
5 The switching time for the contact
is determined by the time for which
the screwdriver is held down.
Using the bus programming soft-
ware BPS 650-... the switching func-
tion/time can now be changed.
3 Select the relevant relay by
actuating the programming mode
button at the BSM 650-... with the
screwdriver until the required LED
lights up (LED 1=relay 1).
6 Continue to program more control
buttons or quit the programming
mode.
105