Compliance With Ul Standard; Compliance With Semi F47 Instantaneous Stop Standard; Compliance With Kc Mark - Panasonic A5N9 Series Reference Specifications

9-4 Compliance with UL Standard

Certified by the UL508C (file No. E164620) standard by observing the installation conditions [1], [2] below.
[1] Use the servo driver under the environment of pollution level 2 or 1 defined in IEC60664-1. (Example:
Installed in the IP54 control panel.)
[2] Make sure to connect a circuit breaker or fuse compliant with UL certification (marked with LISTED,
between the power supply and the noise filter.
For information about rated current of the circuit breaker/ fuse, refer to "9-3 List of Peripheral Devices Applicable
to Servo Driver".
For wiring, use the
The terminal block can
2.0 N • m.).
Overload
[3] protection level
The overload protection
rated current based on the time property. Check that effective current of the servo driver does not exceed the rated
current by monitoring the load factor using PANATERM or by other methods. Set up the maximum instantaneous
allowable current at the Pr 0.13 (first torque limit) and Pr 5.22 (
The servo driver will comply with UL in the power supply environment of 5,000 Arms or lower.
[4]
[5]
Motor over-load-temperature protection shall be provided at the final installation upon required by the NEC
(National Electric Code).

10. Compliance with SEMI F47 Instantaneous Stop Standard

This function corresponds to the F47 power supply instantaneous stop standard in the SEMI standard during

no/ light load condition.
Useful when used in the semiconductor manufacturing equipment.

Warning:
[1] Not applicable to the servo driver which has a single phase 100 V specification and a 24 VDC specification
for control power input.
[2] Make sure to evaluate and confirm the compliance with F47 power supply instantaneous stop standard with
an actual device.

11. Compliance with KC mark

Conformity of Korea Certification mark is registered by suiting EMC directive.
Registration No．KCC-REM-FAN-M-D
R1.0
copper
conductor cable of the temperature rating 60 deg. Celsius or more.
be
damaged if the screw tightening torque exceeds the maximum value (M4: 1.2 N
function
of the servo driver works when the effective current will be 115% or more of the
second torque limit).
Motor Business Unit, Appliances Company, Panasonic Corporation
No. SX-DSV02308 - 57 -
)
U L
•
m, M5: