Fig. 9.3-1 Schematic Diagram Of Length Of Cable Sheath To Be Stripped; Fig. 9.3-2 Schematic Diagram Of Soldering The Core Wire With The Pin; Fig. 9.3-3 Structure Of N-J7A - Zte ZXCBTS Series Installation Manual

ZXCBTS (V5.4) CDMA Micro Base Transceiver Station & Remote Station Installation Manual
2.
1)
2)
3)
3.
1） Assemble an outdoor coaxial cable connector following the same steps
Assembly of a GPS coaxial cable connector
Strip the a segment of sheath off the GPS coaxial cable as required in Fig. 9.3-1.

Fig. 9.3-1 Schematic Diagram of Length of Cable Sheath to be Stripped

Assemble the components onto the cable as shown in Fig. 9.3-2. And then solder
the core wire with the pin. Unfold the shielding layer and wrap it around the
bushing.
Soldering Cable core
Pin
tin wire

Fig. 9.3-2 Schematic Diagram of Soldering the Core Wire with the Pin

Assemble the components into the shell, as shown in Fig. 9.3-3.
Pin
Procedures to install the GPS antenna feeder system
mentioned above.
6.2
16.7
Insulating
Cable shielding
Bushing
washer
Insulating
Bushing
Shell washer

Fig. 9.3-3 Structure of N-J7A

9-4
Crimping tube Nut
Crimping
Nut
tube
Cable