Determining Route For Feeder Cable; Assembling Connectors Of Primary Feeder Cable; Fig. 8.6-1 Structure Of The Feeder Cable Of A Micro-Bts/Remote Station - Zte ZXCBTS Series Installation Manual

8.6.1 Determining Route for Feeder Cable

The cabling route of the feeder cables should be determined according to the
engineering design drawing. If an alteration is necessary, negotiate with the customer
representative for solution. Note that the primary feeder cables should be as short as
possible.

8.6.2 Assembling Connectors of Primary Feeder Cable

Assembling feeder cable connectors is the most important procedure in the
installation of the antenna feeder system, for the quality of them directly
affects the performance of both equipment and network.
Be cautious when using the cutter, for it is very sharp.
This section describes how to assemble connectors for the ROSENBERGER
7/8" feeder cable. For the assembly of connectors for other types of feeder
cable or feeder cable of other manufacturers, refer to the specific installation
manual.

Fig. 8.6-1 Structure of the Feeder Cable of a Micro-BTS/Remote Station

Caution:
Chapter 8 Installation of Primary Antenna Feeder System
Antenna jumper cable
Label
Feeder cable
Label
Customized jumper
cable on top
Male N connector
8-13