Fig. 8.6-2 Cutter For Assembling 7/8" Feeder Cable Connectors; Fig. 8.6-3 Schematic Diagram Of Cutting The Feeder Cable With The Cutter; Fig. 8.6-4 Schematic Diagram Of Correct Cutting Size - Zte ZXCBTS Series Installation Manual

ZXCBTS (V5.4) CDMA Micro Base Transceiver Station & Remote Station Installation Manual
1.
2.
3.
4.
5.
The cutter used is shown in Fig. 8.6-2.

Fig. 8.6-2 Cutter for Assembling 7/8" Feeder Cable Connectors

Pull the feeder cable straight (about 150mm long) at the end to be installed with
a connector, and then strip 50mm-long sheath off the cable with the cutter.
Put the feeder cable on the trough of the cutter EASIAX, reserve four
corrugations at the end of the blade, and then press down the handle. The main
blade should point to one wave crest.
Screw to shut the cutter closely. In this way, the internal and external copper
conductors of the feeder cable are severed, and at the same time the cable sheath
is severed by the assisting blade, as shown in Fig. 8.6-3.

Fig. 8.6-3 Schematic Diagram of Cutting the Feeder Cable with the Cutter

Check if the cutting position is correct, as shown in Fig. 8.6-4.

Fig. 8.6-4 Schematic Diagram of Correct Cutting Size

Wave crest
8-14