Transporting And Raising Antenna; Fig. 8.4-2 Schematic Diagram Of Raising The Antenna To The Tower Top - Zte ZXCBTS Series Installation Manual

ZXCBTS (V5.4) CDMA Micro Base Transceiver Station & Remote Station Installation Manual

8.4.3 Transporting and Raising Antenna

Both the installation personnel working on tower and those working under
tower should cooperate to raise the antenna onto the tower with rope. Note to
keep the antenna away from the tower body to prevent any damage to the
antenna when pulling it up the tower.
Use rope and pulley block to raise the antenna, 3-m antenna jumper cable and other
accessories (including tools, safety belt, adhesive tapes and cable ties) up to the tower
platform, and then put them in a safe place to avoid falling. Note that the fasteners and
other metal tools must be put in a canvas tool bag before pulling them up. When raising
a directional antenna or an omni antenna, tie a knot at each end of the antenna to
facilitate the cooperation between the installation personnel on and under the tower, as
shown in Fig. 8.4-2.
If an antenna is to be installed on the top of a building, carry the antenna and other
accessories to the installation site manually.
Caution:
Rope for
raising the
antenna

Fig. 8.4-2 Schematic Diagram of Raising the Antenna to the Tower Top

Pulley block
Tie a knot with rope at
each end of the antenna
Pull the antenna away from the
antenna to avoid damaging the
antenna
8-8