Checking Outdoor 1/2" Jumper Cables; Checking Antenna - Zte ZXCBTS Series Installation Manual

3.

11.10 Checking Outdoor 1/2" Jumper Cables

Check if:
1.
2.
3.
4.
5.

11.11 Checking Antenna

Check if:
1.
2.
3.
4.
5.
6.
The hangers are installed on the primary feeder cables every 1.5m..
The connections between the antenna and the 1/2" jumper cable as well as the
1/2" jumper cable and the primary feeder cable are correct. Their joints are
tightened.
The jumper cable connected with the antenna is laid along the beam of the
antenna mount and bound to the tower.
The joints between the antenna and the 1/2" jumper cable as well as the 1/2"
jumper cable and the primary feeder are sealed as required (Refer to 9.4.6 and
9.6.6).
The jumper cable keeps straight with the antenna for 30cm long at their joint.
All the connectors of outdoor jumper cables are sealed and water-blocking curve
is made for jumper cables.
The antenna mount is connected firmly with the tower.
The type of the antenna installed meets the requirement of the networking plan.
The height from the center of the antenna to the ground and the installation
position of the antenna comply with the networking plan.
The RF antenna and the GPS antenna are installed in the area protected by the
lightning rod.
The azimuth angle of each single-polarized directional antenna conforms to the
networking plan. Two antennae of one sector are oriented to the same direction.
The deviation of the azimuth angle of a directional antenna is within +/-5°.
The pitch angle of each single-polarized antenna conforms to the networking
plan. The deviation of the pitch angle of a directional antenna is within +/-0.5°.
The pitch angle of two single-polarized antennae is the same.
Chapter 11 Hardware Installation Check
11-7