GE AF-60 LP Programming Manual page 13

* Set-up 1
[1 ]
[2] Set-up 2
[9] Multi Set-up
4
0-11 Edit Set-up
Option:
* Set-up 1
[1 ]
[2] Set-up 2
[9] Active Set-up
0-12 Link Set-ups
Option:
[0] Not linked
* Linked
[1 ]
4.1.2. 0-31 Custom Readout Min Scale
0-31 Custom Readout Min Scale
Range:
*
0.00 [0.00 – 9999.00 ]
4.1.3. 0-32 Custom Readout Max Scale
0-32 Custom Readout Max Scale
Range:
*
100.0 [0.00 – 9999.00]
4.1.4. 0-4* Keypad
The frequency converter can operate in the following three modes: Hand, Off and Auto.
Hand: The frequency converter is locally operated and does not allow any remote control. By activating Hand a start signal is given.
OFF: The frequency converter stops with a normal stop ramp. When Off is chosen the frequency converter can only be started by pressing either Hand or Auto
on the Keypad.
12
• the motor is coasted
OR
• the set-ups between which the shift happens are linked to each other (see par. 0-12, Linked Set-ups).
If changing between set-ups that are not linked, the change will not happen before motor is coasted.
NB!
The motor is only considered stopped when it is coasted.
Set-up 1 is active.
Set-up 2 is active.
Select the active set-up via digital input and/or bus, see par. 5-1* choice [23].
Function:
The Edit Set-up is for updating parameters in the frequency converter from either Keypad or bus. It can be identical
or different from the Active Set-up.
All set-ups can be edited during operation, independently of the active set-up.
Update parameters in Set-up 1.
Update parameters in Set-up 2.
Update parameters in set-up selected as Active Set-up (see par. 0-10).
Function:
The link ensures synchronizing of the "not changeable during operation" parameter values enabling shift from one
set-up to another during operation.
If the set-ups are not linked, a change between them is not possible while the motor is running. Thus the set-up change
does not occur until the motor is coasted.
Leaves parameters unchanged in both set-ups and cannot be changed while motor runs.
Copy parameters "not changeable during operation" parameter values into presently selected Edit Set-up.
NB!
This parameter cannot be changed while motor runs.
Function:
It is possible to create a customized readout related to the output frequency of the unit. The value entered in par. 0-31
will be shown at 0 Hz. The readout can be shown in the LCP display when in Status Mode or it can be read in par. 16-09
Function:
It is possible to create a customized readout related to the output frequency of the unit. The value entered in par. 0-32
will be shown at the frequency programmed in par. 4-14 Motor Speed High Limit. The readout can be shown in the LCP
display when in Status Mode or it can be read in par. 16-09
AF-60 LP™ Micro Drive Programming Guide