Table of Contents
Advertisement
NOTE: 1. Some time is required before an ultrasound image is displayed on the
monitor after the power is turned ON. The time differs depending on the
system conditions, but typically is within 3 minutes.
2. The power shutdown process may take approximately 1.5 to 3 minutes
depending on the system conditions.
3. After the main power has been turned OFF on the power panel, wait for at
least 15 seconds before turning the power ON again.
If the main power switch is turned ON immediately after the power has
been turned OFF, the system may malfunction.
4. If the power of the system is turned OFF suddenly by a power outage etc.,
the LED on the side of the system may flash.
In this case, turn OFF the main power switch on the power panel.
Before turning ON the power again, confirm that the LED is not lit.
If the system cannot be turned ON, the problem is not corrected, or the system operates
abnormally after the above items have been checked, contact your TOSHIBA service
representative.
No. 2B771-004EN*M
22-2
*
Advertisement
Table of Contents
