Toshiba Aplio 500 TUS-A500 Operation Manual page 125

Moving the FLEX-M cursor
Adjusting the angle and position of the FLEX-M cursor
Switch
NOTE: 1. M gain adjustment
In FLEX-M mode, an M-mode image is reconstructed from a 2D-mode
image. Therefore, it is not possible to change the gain of the M-mode
image independently of the 2D-mode image.
2. Length of the FLEX-M cursor
The length of the FLEX-M cursor can be adjusted. The length of the
FLEX-M cursor corresponds to the vertical axis scale of the M-mode
image display area.
3. The FLEX-M cursor length displayed on the
changed in cm. Even when the dial corresponding to this switch is
rotated, the displayed value does not change if the change in the cursor
length is less than 1 cm.
Operate the trackball to move the FLEX-M cursor to the
desired position.
Angle adjustment
Length adjustment
Horizontal shift (effective only when the image is
frozen)
Vertical shift (effective only when the image is frozen)
No. 2B771-004EN*M
14-19
Function
switch is