YASKAWA MOTOMAN DX200 Instructions Manual page 19

175386-1CD
[Operation at Pendant Connection Box Side]
7. Turn OFF (extinguish) the illuminated pushbutton switch by pressing it.
8. Connect the relay cable to the connector (EX. CABLE X82).
9. Connect the pendant cable which is disconnected at the step 4 to the connector
(PENDANT CABLE X81) of the pendant connection box.
10. Turn ON (lighten up) the illuminated pushbutton switch, which is operated at the step 7,
by pressing it.
Confirm that the initial window is displayed after the start up window is displayed on the
programming pendant screen. Confirm that the programming pendant started up
properly, and then perform the ordinary operations.
11. Pay careful attention to surroundings, and restore the emergency stop button of the
DX200 or the programming pendant.
3 Procedures for Replacing Operation
- 3-3 –
HW1483491
19 of 22