Program Setup - DEMA CPM 310 G User Manual

Program Setup

Setup Dialogue 1
Setup Dialogue 2
DEMA DigiConnect program setup may be launched by the
following ways.
1. For operating systems where CD-ROM or DVD-ROM is set
as to enable auto-start, the setup process will launch
automatically when the DigiConnect CD is inserted into
the optical disc drive.
2. If by any reason the setup does not start automatically,
follow one of the methods described below:
a. Go to the optical drive address (e.g. D:\) and
double-click the Setup.exe file; that will launch
the setup process,
b. alternatively, launch the Run tool located under
the Start menu, and type the following
command:
D:\setup.exe
Note that the command line above is given as
an example assuming that the optical drive
address is D:\. The drive address may vary by
the hardware and software configuration of
your PC. On such a case, replace the "D:\"
address by, e.g., E:\ or whatever the drive
address is. The address of your optical drive may
be found out by exploring My Computer
window, usually located on and launched from
the Desktop.
Once the program setup is launched the screen shown on the
Setup Dialogue 1 pops up and is monitored for a while.
During the time, the operating system copies the needed files
for the setup to the PC memory and hard drive. After the
process is completed, the screen disappears and replaces
with the menu shown on the picture Setup Dialogue 2.
This menu contains the text below:
Welcome to the DigiConnect v3.1 installation program.
Setup cannot install system files or update shared files if they
are in use. Before proceeding, we recommend that you close
any applications you may be running.
Following the instructions by the setup, please close all other
application that may be running and continue with the setup
by clicking the button OK. If you want the setup process to be
terminated at this step, you may use the Exit Setup button. ↘
- 130 -