Non-Compatible Material - Brother ScanNCut DX Manual

Non-Compatible Material

The following material cannot be used, even if it has backing paper or backing film. The material may separate and cause jamming
during cutting.
■ Material whose end curls upward when the roll is loaded with the backing paper or backing film
facing down
Be sure to check this when using iron-on transfer material.
If the end of the material curls upward, cut it to the appropriate size, and then attach it to a mat.

Otherwise, the material may become jammed in the machine.
a Rolled with the backing paper (backing film) on the outside
a Rolled with the backing paper (backing film) on the inside
■ Material whose left and right edges are not parallel
Left and right edges are not parallel.
●
Left and right edges are parallel.
●
1
1
Note
• If the rolled iron-on material is 610 mm (24") long or shorter,
we recommend you use our 12" × 24" (305 mm × 610 mm)
optional cutting mat.
• If the rolled material is longer than 610 mm (24"), cut into 610
mm (24") long or shorter, then use our 12" × 24" (305 mm ×
610 mm) optional cutting mat.
While the material feeds, it loses contact with a feed roller,
causing the material to become skewed and feed incorrectly.
The material feeds correctly.
When the end of the material curls
upward, it will not feed correctly.
When the end of the material is flat or
curls downward, it will feed correctly.
35