Consumables/Maintenance; Replacement Criteria; Replacing The Trimmer Blade - Brother ScanNCut DX Manual

Roll feeder
Hide thumbs

Advertisement

Table of Contents

Consumables/Maintenance

Replacement Criteria

For the safe operation of this machine, replace the following
consumables according to the replacement criteria. To
purchase parts, contact the retailer where this product was
purchased or the nearest Brother authorized service center. For
details on optional accessories, refer to the Operation Manual
for the cutting machine, or see page 2 in this manual.
Cutting Blade
Replace when:
• the cuts in the material become rough, reducing the quality of
the finished product
• the cutting edge becomes dull
• the blade is chipped (If it cannot cut even though the blade
extension or cutting pressure is set higher than necessary, the
blade may be chipped.)
For details on replacing the blade or cleaning the holder, refer
to the Operation Manual for the cutting machine.
Trimmer Blade
Replace when:
• the cuts in the material become rough or the material cannot
be cleanly cut off
• the cutting edge becomes dull
• the blade is chipped
Memo
• Do not disassemble the trimmer blade.

Replacing the Trimmer Blade

■ Removing the Trimmer Blade
1
a Stopper
a
Lightly push back on the stopper at the left end of the
trimmer.
The stopper will be shifted downward so that the trimmer
blade can be removed from the trimmer.
a Stopper
Memo
• Do not push on the stopper with force. Otherwise, damage
may result.
b
Slide the trimmer blade to the left end to remove it from
the trimmer.
1
25

Hide quick links:

Advertisement

Table of Contents
loading

  Also See for Brother ScanNCut DX

Table of Contents