Feeding The Material - Brother ScanNCut DX Manual

Feeding the Material

a
While keeping the left edge of the material aligned with
the rolled material guide, lightly insert the material under
the left and right feed rollers. While holding the material
inserted under the feed rollers so that the material does
not shift, press in the operation panel.
1
a Rolled material guide
b Feed rollers

When the material is fed into position, preparation of the roll
feeder is completed. At this time, make sure that the left and
right feed rollers completely pass over the material.
Memo
• If the material becomes jammed, remove any jammed
material. For details, see "When Material Has Become
Jammed in the Machine" on page 30.
14
2