Checking The End Of The Material - Brother ScanNCut DX Manual

Roll feeder
Hide thumbs

Advertisement

Table of Contents
b
While squeezing the adjustment lever, slide the right
guide plate against the roll to correctly align the left edge
of the material.
a Adjustment lever
Note
• The material is correctly loaded when there is a gap of
about 2 to 3 mm between the guide plate and the right side
of the roll. After aligning the left edge of the material, adjust
the guide plate.
a Gap of about 2 to 3 mm
1
1

Checking the End of the Material

Make sure that the end of the material is evenly trimmed to
meet all of the following conditions.
a It must be straight.
b The left and right edges of the material must be parallel.
If the material does not meet both (1 and 2) of the conditions
described above, it may not be fed correctly.
Before feeding the material, be sure to check this.
11

Hide quick links:

Advertisement

Table of Contents
loading

  Also See for Brother ScanNCut DX

Table of Contents