Cutting - Brother ScanNCut DX Manual

Roll feeder
Hide thumbs

Advertisement

Table of Contents
d
Confirm the data, and then touch the "OK" key.
b
a Switch the pattern display.
Select
to display the pattern enlarged to a 12-inch
area.
Select
to display the pattern reduced to show all of it.
b Scroll down through the pattern
c Delete the data
The preview screen appears.
Memo
• When the pattern is displayed reduced, a maximum cutting
length of 1,785 mm (70.3") is displayed, regardless of the
size of the pattern. If the pattern is shorter than 1,785 mm
(70.3"), the pattern will be displayed with space added;
however, cutting will stop at the bottom of the pattern. The
additional space will not be included in the cutting data.
16
a
c

Cutting

Make sure that the auto blade holder has been installed in
the carriage of the machine. For details on the blade holder
that can be used, see "Blades That Can Be Used" on
page 36.
a
Raise the scanner lever (on the left side of the machine) to
"2".
b
Select "Cut" in the preview screen.
• Touch
to confirm the instructions for installing the roll
feeder.
c
To perform trial cutting, touch the "Test" key.
• In order to cut your project properly, perform trial cutting
before cutting the pattern. For details, see "Trial Cutting" on
page 18.
Memo
• When the roll feeder is used, half-cutting is automatically
turned on. Touch
d
see step
in "Changing the cut pressure setting" on
page 19.
to check the settings. For details,

Hide quick links:

Advertisement

Table of Contents
loading

  Also See for Brother ScanNCut DX

Table of Contents