Brother ScanNCut DX Manual page 14

e
Make sure that the trimmer blade is positioned at the
right end of the trimmer.
a Trimmer blade
b Trimmer
Note
• The trimmer blade can cut material only when it is slid from
the right end of the trimmer. It cannot cut if it is slid from
any location other than the right end.
f
While keeping the left edge of the material aligned with
the rolled material guide, firmly press the trimmer down
on the right side of the material. While holding them in
place, slide the trimmer blade from right to left to cut off
the material.
Slide the trimmer blade while pressing down gently.
2
1
a Rolled material guide
b Trimmer
c Trimmer blade
Note
If the material does not cut easily:
• If cutting does not start smoothly, for example, if the
material catches on the blade, instead of sliding the blade
with excessive force, refer to the following and try again.
Sliding the trimmer blade with excessive force may cause
damage.
- If the material is not very pliable, firmly press the
trimmer down on the right side of the material.
- If the material is fairly pliable and has a strong curl,
firmly press the trimmer down at the center.
2 1
3
g
Return the trimmer blade to the right end of the trimmer,
and then remove the trimmer.
Remove any material that has been trimmed off.
1
a Trimmer
Memo
• The removed trimmer can be stored at the front of the roll
holder.
13