Installing The Roll Holder; Loading Material Into The Roll Feeder - Brother ScanNCut DX Manual

Roll feeder
Hide thumbs

Advertisement

Table of Contents
g
Return the feeder release lever (on the right side of the
machine) to its original position.
a Feeder release lever
Only the right side of the shaft is lowered, and the shaft is
locked.
h
Install the base attachment so that its end hooks onto the
shaft.
a Base attachment
b Shaft
Note
• If the feed roller is not correctly positioned, the base
attachment cannot be installed correctly. Make sure that
the feed roller is moved to the position for using the roll
feeder.
• Press on the base attachment to firmly secure it to the
shaft.
• Make sure that the base attachment is secure against the
front tray cover.
10

Installing the Roll Holder

a
1
2
b
1

Loading Material Into the Roll Feeder

a
Place the roll holder down so that its hooks fit into the
holes in the front tray cover.
2
a Hooks on roll holder
b Holes in front tray cover
Flip up the guide plate on each side of the roll holder.
1
a Guide plate
Insert the material so that the pin on the left guide plate
fits into the paper core of the material, and then place the
roll on the four support rollers.
Be sure to load the material so that it unrolls from the top
and the side to be cut faces up.
a
a
b
a Pin on guide plate
b Support rollers
1
1

Hide quick links:

Advertisement

Table of Contents
loading

  Also See for Brother ScanNCut DX

Table of Contents