Brother ScanNCut DX Manual page 32

■ When Jammed Material Cannot Be
Removed
Cut-off material may not feed out from the back of the machine.
Follow the procedure below to remove any jammed material.
Note
• After cutting off material with the trimmer blade, material
being fed out to the back of the machine may be too short
and remain in the machine.
a
Press in the operation panel to turn off the machine.
b
Unplug the power cord from the electrical outlet.
c
Completely remove the rear tray from the machine.
• For details on removing the rear tray, refer to the Operation
Manual for the cutting machine.
d
Remove any jammed material.
a Jammed material
e
Install the rear tray onto the machine.
• For details on installing the rear tray, refer to the Operation
Manual for the cutting machine.
f
Insert the plug of the power cord into an electrical outlet.
g
Press in the operation panel.
When the opening screen appears, touch anywhere on the
display.
a
31