Continuous Cutting - Brother ScanNCut DX Manual

Continuous Cutting

After cutting a pattern, you can continue to cut either the same
pattern or a different pattern without cutting off the material.
Note
• The maximum length (in the feeding direction) of the
material that can be cut after loading is 1,785 mm (70.3")*.
When cutting material longer than the specified length, cut
off the material and feed it out, and then insert the material
again to continue cutting.
* This depends on the material and operating conditions
specified by Brother.
■ Repeatedly Cutting the Same Pattern
a
Touch "Continue to cut".

The preview screen appears.
b
Select "Cut" in the preview screen, and then touch the
"Start" key to start cutting.

The pattern that is displayed is cut.

Cutting start from the bottom edge of the last pattern that was
cut.
22
Memo
• To change the cutting start position, see "Changing the
Cutting Start Position" on page 21.
• The cutting start position can also be adjusted by adding
space at the beginning of the cutting data while it is being
created. For details, see "Creating Cutting Data" on
page 5.
■ Continuing To Cut With a Different Pattern
a
Touch "Continue to cut".

The preview screen appears.
b
Touch in the preview screen.

When is touched, the message "OK to delete data
showing on the screen?" appears.
Touch the "OK" key.
c
Select "Start to cut rolled material", and then retrieve a
different pattern.
• For details, see "Retrieving Data on the Machine" on page 15.
Memo
• To change the cutting start position, see "Changing the
Cutting Start Position" on page 21.
• The cutting start position can also be adjusted by adding
space at the beginning of the cutting data while it is being
created. For details, see "Creating Cutting Data" on
page 5.