Danfoss VLT HVAC Drive FC 100 Operating Instructions Manual page 78

4. How to Programme
All digital input/output and analog input/output terminals are multifunctional. All terminals have
factory default functions suitable for the majority of HVAC applications but if other special functions
are required, they must be programmed as explained in parameter group 5 or 6.
4.4. Parameter Options
4.4.1. Default settings
Changes during operation
4
"TRUE" means that the parameter can be changed while the frequency converter is in operation
and "FALSE" means that the frequency converter must be stopped before a change can be made.
4-Set-up
'All set-up': the parameter can be set individually in each of the four set-ups, i. e. one single
parameter can have four different data values.
'1 set-up': data value will be the same in all set-ups.
Conversion index
This number refers to a conversion figure used when writing or reading by means of a frequency
converter.
Conv. index
Conv. factor
Data type
2
3
4
5
6
7
9
33
35
54
78
100 67 6 5 4
1 1/60 100000 100000 10000 1000
0
Description
Integer 8
Integer 16
Integer 32
Unsigned 8
Unsigned 16
Unsigned 32
Visible String
Normalized value 2 bytes
Bit sequence of 16 boolean variables
Time difference w/o date
MG.11.F1.02 - VLT
3 2 1 0 -1 -2
100 10 1 0.1 0.01
® is a registered Danfoss trademark
®
VLT HVAC DRIVE High Power
Operating Instruction
-3 -4 -5 -6
0.00 0.000 0.0000 0.000001
1 1 1
Type
Int8
Int16
Int32
Uint8
Uint16
Uint32
VisStr
N2
V2
TimD