Danfoss VLT HVAC Drive FC 100 Operating Instructions Manual page 40

3. How to Install
3
Illustration 3.57: Installation of bottom duct
Install the front cover of the duct and the ca-
ble clamp base if used. Install the two remain-
ing gland plates.
40
After the bottom ductwork has been posi-
tioned in place, remove the three T25 screws
from the outer holes in the mounting brackets
on the sides and front of ductwork and move
them to the inner holes of the same brackets.
Tighten the three screws to the specified tor-
que. The bottom duct work is not fastened to
Rittal enclosure.
Illustration 3.58: Move mounting screws from the
outer hole to the inner hole
Illustration 3.59: Bottom duct installed.
MG.11.F1.02 - VLT ® is a registered Danfoss trademark
®
VLT HVAC DRIVE High Power
Operating Instruction