Installing A 5.25" Adapter Module For Removable Trays - Siemens SIMATIC IPC847E Operating Instructions Manual

6.6.1.4

Installing a 5.25" adapter module for removable trays

You can find information on the correct mounting location for this adapter module can be
found in "Permissible expansion for temperature range 0 to 40 °C (Page 100)" and
"Permissible expansion for temperature range 0 to 50 °C (Page 102)".
Requirement
● The device is equipped with the drive cage type A.
● There is no drive or any other component in the mounting location for 5.25" components.
● An original spare part, that is a 5.25" adapter module approved for this device, see notes
in "Hardware accessories (Page 30)".
● The device is fully disconnected from the line voltage, see "Switching off the device
(Page 60)".
● The device is open, see important information in "Open the device (Page 89)".
Procedure
1. Unlock the drive mounting bar together with the blanking plate by pressing laterally
against the surfaces
direction of the arrow.
2. Remove the blanking plate.
SIMATIC IPC847E
Operating Instructions, 10/2018, A5E43920357-AA
Expanding and assigning parameters to the device
①
and push the drive mounting bar forward from the device in the
6.6 Drives
107