Siemens SIMATIC IPC847E Operating Instructions Manual page 92

Expanding and assigning parameters to the device
6.2 Expansion cards
Procedure
1. Loosen the cable holder
2. Hold the bar with the card
retainer
remove it by pulling it upwards.
The bar is latched on both ends.
3. Remove the slot bracket
required slot.
4. Insert the expansion card into the
free slot
5. Secure the expansion card with the
screw
6. Reinstall the rod with the card
retainer
7. Detach the card retainer in question
and place it on the expansion card in
the slo
8. Secure the card retainer with the
locking screw
If you are installing a short
expansion card, remove the locking
screw from the card retainer and
install it in the opposite hole.
If you are installing a low-profile
expansion card, use the longer card
holder for mounting (included in
product package).
9. Secure the cables with the cable
holder
10. Close the device.
92
③
.
①
on both ends and
④
for the
⑥
.
⑤
.
①
.
⑥
.
②
.
③
.
Operating Instructions, 10/2018, A5E43920357-AA
SIMATIC IPC847E