Removing And Installing The Display For The Pc Fi45 V2; Removing And Installing The Touch Pad For The Pc Fi45 V2; Removing And Installing The Front Adapter Module For The Pc Fi45 V2 - Siemens SIMATIC Box PC 820 Manual

System Unit
1.3.16

Removing and Installing the Display for the PC FI45 V2

S
Lower the system box of the PC FI45 V2 away from the front panel as
described in Section 1.3.2 or remove the membrane keyboard as described in
Section 1.3.13.
S
Remove the two screws with which the support for the inverter module is
mounted.
S
Before you unplug all the connectors, write down their arrangement.
S
Remove the display connector.
S
Remove the four screws with which the display is secured and then remove the
display.
To install the display, proceed in reverse order.
1.3.17

Removing and Installing the Touch Pad for the PC FI45 V2

S
Remove the membrane keyboard as described in Section 1.3.13.
S
Remove the three touch pad module screws on the installation plate.
S
Remove the installation plate and the copper-colored sheet-metal spring
underneath.
S
Take out the touch pad module and detach the flexible cord (contact side faces
module).
To install the touch pad, proceed in reverse order.
1.3.18 Removing and Installing the Front Adapter Module for the
PC FI45 V2
S
Lower the housing of the PC FI45 V2 away from the front panel as described in
Section 1.3.2, or remove the membrane keyboard as described in Section
1.3.13.
S
Before you unplug all the other connectors, write down their arrangement.
Caution
!
Before you remove the membrane connecting cables, release the interlocks on
the ports so that the contacts of the connecting cables are not damaged.
S
After removing the three screws; then you can remove the front adapter
module.
To install the front adapter module, proceed in reverse order.
1-28
Box PC 820 / PC FI45 V2, Manual
A5E00051531-03