Safety Instructions - Terbly TP02-CW User Manual

1. SAFETY INSTRUCTIONS

1.1. IMPORTANT SAFETY WARNING
This device has left the factory in perfect condition. In order to maintain this condition and to
ensure safe operation, it is absolutely necessary for the user to follow the safety instructions and
warning notes written in this user manual.
In order to install, operate, and maintain the lighting fixture safely and correctly we suggest that
the installation and operation be carried out by qualified technicians and these instructions be
carefully followed.
HIGH VOLTAGE. RISK OF SEVERE OR FATAL ELECTRIC SHOCK
ALWAYS DISCONNECT MAINS SUPPLY BEFORE REMOVING ANY FIXTURE
COVERS
NEVER LOOK DIRECTLY INTO THE LIGHT SOURCE. SENSITIVE PERSONS
MAY SUFFER AN EPILEPTIC SHOCK
NEVER TOUCH THE DEVICE DURING OPERATION! COVERS MAY BE HOT
KEEP THIS DEVICE AWAY FROM RAIN AND MOISTURE
Important:
Damage caused by the disregard of this user manual is not subject to warranty. The
dealer and manufacturer will not accept liability for any resulting defects or problems.
 If the device has been exposed to temperature changes due to environmental conditions,
do not power on immediately. The resulting condensation could damage the device. Leave
the device powered off until it has reached room temperature.
 This device falls under protection-class I. Therefore, it is essential that the device be
earthed.
 If either lenses or display are damaged (damage may include cracks or gashes in the
material) they must be replaced.
 Electrical connections, such as replacing the power plug, must be performed by a
qualified person.
 Make sure that the available voltage is not higher than that which is stated at the end of
this manual.
 Make sure the power cord is never crushed or damaged by sharp edges. Should the power
cord suffer If this should be the case, replacement of the cable must be done by an
TP02-CW,WW User Manual
CAUTION!
CAUTION!
CAUTION!
CAUTION!
CAUTION!
2 XM1268/1257-V1.0-NR