Table of Contents
Advertisement
"Clear Last Run".
4. The display show "OFF",Press <Up/Down>, the display will show "ON".
5. Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.2.2. Temperature Info
Head Temp.
With this function you can display the temperature on the display board of the base (near
CMY-filter) in Celsius.
1. Tap <MODE/ESC> button，access the main menu，Tap the <Up/Down> button until
"Information" is displayed. Press ENTER, the display will show "Information". Tap the
<Up/Down> button until "Temperature Info" is displayed. Press ENTER, the display
will show "Temperature Info".
2. Press <Up/Down>, the display will show "Head Temp.".
3. Press< ENTER>, the display will show "Head Temp.".
4. The display show "XXX °C/ °F".
5. Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.2.3. Soft Ver
With this function, you can display the software version of the device.
1. Tap <MODE/ESC> button，access the main menu，Tap the <Up/Down> button until
"Info" is displayed. Press ENTER, the display will show "Info".
2. Press <Up/Down>, the display will show "Soft Ver".
3. Press< ENTER>, the display will show "Soft Ver".
4. The display show "Ver x.x.x".
5. Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.3. PERSONALITY
9.3.1. Status Settings
Address via DMX
With this function, you can adjust the desired DMX-address via an external controller.
1. Access the main menu.
2. Press <Up/Down>, the display will show "Address via DMX".
3. Press< ENTER>, the display will show"Address via DMX".
4. The display show "ON",Press <Up/Down>, the display will show "OFF".
5. Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
No DMX Status
With this function, when the drive is not DMX signal, it runs automatism, close, hold and
music, the default is hold.
1. Access the main menu.
2. Press <Up/Down>, the display will show "No DMX Status".
3. Press< ENTER>, the display will show"No DMX Status".
4. The display show "Hold",Press <Up/Down>, the display will show "CloShut",
"Auto".
5. Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
Hibernation: Standby mode
TP02-CW,WW User Manual
14
XM1268/1257-V1.0-NR
Advertisement
Table of Contents
