Table of Contents
Advertisement
2. FIXTURE OVERVIEW
1) Lampshade (Options)
2) Focus
3) UP- button
4) DOWN- button
5) Mode/Esc- button
6) ENTER- button
7) Display
8) Fuse
3. SAFETY INSTRUCTIONS
3.1) Important safety warns
This device has left the factory in perfect condition. In order to maintain this condition and to
ensure a safe operation, it is absolutely necessary for the user to follow the safety instructions and
warning notes written in this user manual.
Important:
Damages caused by the disregard of this user manual are not subject to warranty. The
dealer will not accept liability for any resulting defects or problems.
If the device has been exposed to temperature changes due to environmental changes, do not
switch it on immediately. The arising condensation could damage the device. Leave the device
switched off until it has reached room temperature.
This device falls under protection-class I. Therefore it is essential that the device be earthed.
If protection screen, lens or ultraviolet screen in the fixture is apparently damaged or is damaged
to exceed their own effective degree, such as cracked and gashed, it must be replaced.
The electric connection must carry out by qualified person.
Make sure that the available voltage is not higher than stated at the end of this manual.
Make sure the power cord is never crimped or damaged by sharp edges. If this would be the case,
9) 5-Pin DMX Out
10) Power Out
11) Power In
12) 5-Pin DMX In
13) Floor-stand
14) Cutter
3
XM1193-V1.0 -E
Advertisement
Table of Contents
