Specifications - Lectrosonics DBu Instruction Manual

Digital belt pack transmitter
Hide thumbs Also See for DBu:
Table of Contents

Advertisement

Specifications

Frequency Range:
470.100 - 607.950 MHz
Frequency Selection:
Steps:
25 kHz
RF Power Output:
Selectable; 25 or 50 mW
Frequency Stability:
± 0.002%
Digital Modulation:
8 PSK
Equivalent Input Noise: –128 dBV
Input Level:
Nominal 2 mV to 300 mV, before limiting
Greater than 1V maximum, with limiting.
Input Impedance:
• Mic: 300 Ohm
• Line: 2k Ohm
Input Limiter:
Dual envelope type; 30 dB range
Gain Control Range:
44 dB in 1 dB steps; digital control
Modulation Indicators: • Dual bicolor LEDs indicate modulation of
-20, -10, 0 and +10 dB referenced to full
modulation
• LCD bar graph
Controls:
• Top panel toggle switch; programmable
as power, mute, talkback or none (off)
function
• Side panel membrane switches with LCD
interface for power on/off and all setup
and configuration controls
Audio Input Jack:
Switchcraft 5-pin locking (TA5F)
Antenna:
Galvanized steel, flexible wire
Battery:
Two AA Lithium recommended
Battery Life:
5 hours; Lithium
Weight:
6.24 ounces (177 grams), including two AA
batteries and wire belt clip
Dimensions:
3.2 x 2.5 x .74 in. (86 x 62 x 19 mm)
Emission Designator:
200KG1E
Specifications subject to change without notice.
For body worn operation, this transmitter model has been tested and meets the FCC RF exposure
guidelines when used with the Lectrosonics accessories supplied or designated for this product. Use of
other accessories may not ensure compliance with FCC RF exposure guidelines. Contact Lectrosonics
if you have any questions or need more information about RF exposure using this product..
This device complies with FCC radiation exposure limits as set forth for an uncontrolled environment.
This device should be installed and operated so that its antenna(s) are not co-located or operating in
conjunction with any other antenna or transmitter.
This device complies with ISED Canada radiation exposure limits as set forth for a controlled
"professional" use only.
Cet appareil est conforme avec les normes d'Industrie Canada concernant les limites d'exposition aux
radiations pour un usage professionnel contrôlé seulement.
Rio Rancho, NM
Digital Belt-Pack Transmitter
19

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DBu and is the answer not in the manual?

Questions and answers

Table of Contents