2
A
T
G
BOUT
HIS
UIDE
How to Use
This Guide
Conventions
This table shows where to find specific information in this guide.
If you are looking for...
An introduction to the hub, workgrouping and segments
Information on how the PS Hub 40 and PS Hub 50 are different
from each other
Information on installing and using the hub
An introduction to load balancing and how it works
Ways you can manage the hub and how to start your
management session
Information on using the Command Line Interface to set up
the hub for management
Information on using the web interface to manage the hub or
stack of hubs
Information on
solving any problems
The hub's dimensions, the standards it conforms to, and the
cabling you can use with it
Information on using Quick Config Manager to manage the hub
or stack of hubs
Information on installing and using the serial web utility
Information on using the agent upgrade utility
Technical support
Table 1 and Table 2 list conventions that are used throughout this
guide.
Table 1
Notice Icons
Icon
Notice Type
Information note
Caution
Warning
Alerts you to...
Important features or instructions
Risk of system damage, loss of data, or to personal
safety.
Risk of severe personal injury
Turn to...
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Chapter 8
Appendix A
Appendix B
Appendix C
Appendix D
Appendix E
Need help?
Do you have a question about the PS Hub 40 and is the answer not in the manual?
Questions and answers