3Com PS Hub 40 User Manual page 158

C-2 A C: S
PPENDIX ERIAL
W U
EB TILITY
4 In the Run dialog box, type
(where is the letter of your CD-ROM drive) and click OK.
drive
The installation program starts and checks your system configuration;
enter any information that's requested.
If the setup program cannot find specific files on your management
station, it asks you to insert you Windows '95 CD-ROM. If it still cannot
find the files, you must obtain them directly from Microsoft. Contact
Microsoft for more information.
5 When the installation program has ensured all the relevant files are
installed, it asks you to select the COM port. This is the serial port on
your management station that you are going to use when connecting
to the hub's console port.
If you click Advanced, the Advanced Configuration Parameters dialog
box is displayed, showing all of the settings the serial web utility will
use when it is run. These default settings are already correct for
connection to the hub so you should not need to change them.
The fields are:
Connection name Allows you to enter a name for the connection.
Modem name Allows you to enter a name for the modem connection.
PC SLIP Address The SLIP address that is to be allocated to the
management station. The default address is '192.168.101.2'.
Device URL The URL that the serial web utility uses to access the hub,
which includes the hub's SLIP address. For example, the default SLIP
address for the hub is '192.168.101.1' so the URL is:
http://192.168.101.1/
Flow Control None / XON/XOFF / Hardware RTS/CTS
Allows you to specify the flow control that the management station is
to use.
Data bits , Stop bits and Parity are all fixed.
Speed 1200 / 2400 / 4800 / 9600 / 19200
Allows you to specify the baud rate that the management station is to
use.
You also have the option of changing the PC SLIP Address, Device URL,
Flow Control and Speed after the installation is complete.
drive :\Win95\Drivers\Slip\SETUP
DUA1640-5AAA02