This page is used to select which cascaded segments the active
segment switch is attached to. Click on the checkboxes to connect or
isolate the switch as necessary.
This functionality is only available for the PS Hub 50.
For information on the segment switch, refer to "How Does the
Segment Switch Work?" on page 2-3.
To add or edit the permanent address entries in the active segment
switch's database, click Permanent Address Management. The
Permanent Address Management page is displayed.
This page is used to add or edit permanent addresses in the active
segment switch's database, as shown in Figure 7-11.
Permanent Address Management Page
The fields are:
MAC Address The MAC address of the device.
Segment The cascaded segment to which the device is connected.
Adding and Deleting Permanent Addresses
To add a permanent address to the switch database, click Add.
The Add a Permanent Address page is displayed. Enter the MAC
address of the device and the cascaded segment to which the device is
connected, and then click Add Address to Switch Port.
To delete a permanent address from the switch database, click on the
entry in the list and then click Delete. The permanent address is made
non-permanent. Non-permanent addresses are removed from the
segment database (known as ageing) if they are not used.